説明
Ergonomic handle that fits around the original one. Handle stub must be removed for installation. A new loader retention lever must be installed beforehand. Make sure to compress the retention lever spring in order to slide the handle. To obtain a rendering similar to the one shown in the photo, activate the Fuzzy skin setting on cura and set the parameters below. You may need to use light sandpaper to adjust certain parts to your printer's tolerances. Take care to clean all supports thoroughly. The model was designed on a Mac10 M11 GBB from HFC, I would not be held responsible for a compatibility problem on other models. airsoft #fakegun
About this model
mac10 ergonomic handle is a 無料 3D model in the その他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
