説明
i have tried at 0.3mm and it wasnt great so now doing 0.2 and the curves are holding up nicely. Get your heat settings right or this will develop a fluffly wall of string. concentric infill is a must otherwise your printer will waste time doing .75mm long zig zags. It wont however be doing that all the way up, just occasionally. I also opted for concentric top/bottom layers just to be sure. i planned to upload a dxf stensil for the photo's but it wouldnt quite fit my printer. i had to knock it down to 95% and now it seems you are on your own with that one. trial and error. if i nail it, i will add it.
About this model
Picture Frame is a 無料 3D model in the その他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
