Radius Storm Lantern replacement Knobs (Pre supported)
- 14 閲覧
このモデルは Cults3D で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。
Cults3D で見る ↗説明
Decorative, and as close to original (part numbers 103/22 and 119/22) as possible, replacement knobs for the Radius storm lanterns and similar (As with most retro Swedish storm lanterns, many parts are interchangeable; these fit on a lot of different models. i.a. Radius 101, 102, 103, and Radius 146, 148, 119 respectively to name a few). NOTE: These parts have metal inserts/washers that are needed for them to fit the lanterns. It's designed/prototyped with resin and not filament printing, so bear in mind I haven't confirmed success with filament. I do doubt that it would be a problem though, since it prints excellently in resin on 0,05 mm layer height (your average FDM printer with 0,1 mm would in this case half the "resolution"). The presupported lychee slicer file(s) are designed for resin 3d printing; filament will require you to support and slice additional files.
About this model
Radius Storm Lantern replacement Knobs (Pre supported) is a 無料 3D model in the その他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
