FolgerTech FT-6 Buck Converter Mounting Bracket

説明

Buck converter mounting bracket for a FolgerTech FT-6. Requires: • Soldering • (2) M3x12 screws (used to mount bracket to ACM panel • (2) M3x6 button head screws (used to mount buck converter to bracket) • (2) M3 Nyloc nuts You could do away with the need for the M3x12's and the Nyloc nuts by simply using double-sided sticky tape that comes with the machine to mount the bracket to the ACM panel while still utilizing the bracket. Steps (Basic): • Decide where you are going to mount the buck converter while keeping wire lengths in mind. • Use the buck converter bracket as a template to mark the desired mounting location to be drilled (hexagon nut holes) • De-solder plug wires from buck converter • Feed loose plug wires through the front side of bracket through one of the wire slots (either side is fine) and re-solder the plug wires to buck converter inward/facing one another to prevent wire interference with the bracket and the buck converter. • De-solder power lead wires and re-solder orientated inward/facing one another to prevent wire interference in between the bracket and the buck converter. • Feed power lead wires through the front side of bracket from buck converter. • Insert two M3 Nyloc nuts into the hexagon shaped holes (these should fit snug to prevent turning in the holes) • Carefully (at your own risk) screw buck converter to bracket using two M3x6 screws (Do not over tighten) • Guide wires out the ends of the bracket through the provided channels and install…