10-inch propeller case
- 22 閲覧
このモデルは Thingiverse で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。
Thingiverse で見る ↗説明
So I had an unfortunate experience where I have stuffed loose propellers in my backpack and had one of them bent and break immediately after takeoff which crashed my drone. I decided that something had to be done, but the only cases I found where for 5-inch props. So there is my take on this concept, but for 10 inches.A case for 4 10-inch propellers, 2 cw and 2 ccw. Can be vertically extended to fit more than 4, with each propeller being 10mm high, and each switch from cw to ccw and back requiring additional 5mm. 3 latches slip on from above or side and hold on pretty well. 1 will hold, but at least 2 recommended to be safe.No supports required, but brims for latches are recommended.
About this model
10-inch propeller case is a 無料 3D model in the コスプレ・小道具 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.
