Gridfinity Kitchen Containers

説明

A set of Gridfinity-compatible kitchen and cutlery drawer bins with full-height handle cutouts in the side walls, so you can lift contents out without tipping the bin. Generated parametrically with count-spatula so if none of these sizes fit your drawer, the free generator can make one that does.Print bins bigger than your bed. The handle cutouts are aligned to the Gridfinity 42 mm grid: the cutout floor reaches 1 mm past its internal grid line, so you can cut the model on a grid line in your slicer and print an oversized bin in clean sections. The chopping-board bin (251.5 mm long) prints on my 3D printer which has a 220 mm bed this way.The binsChopping-board bin (4×6, 8U) holds a small chopping board upright (220 × 160 mm pocket, 35 mm corner radius). Footprint 167.5 × 251.5 mm; split on a grid line for smaller beds.Cutlery bin, 3 columns (2×4, 8U) is an everyday cutlery-drawer bin: one pocket split into three equal columns by straight dividers. The handle cutout runs through the dividers. Footprint 83.5 × 167.5 mm.Wave cutlery bin, 3 columns (2×4, 8U) is the same bin as above, but with S-curve wave dividers (6 mm amplitude). Adjacent channels alternate orientation so tapered cutlery nests head-to-tail.Kitchen bin (2×4, 8U) is the plain, undivided bin with handle cutouts; the simplest one to try first and fill out any gaps left in your drawer.All bins sit on a standard Gridfinity base (footprint N×42 mm − 0.5 mm) and have 56 mm (8-unit) interior walls.PrintingNo supports…