Printable Hand Vise by Blech Eimer
- 12 閲覧
このモデルは MyMiniFactory で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。
MyMiniFactory で見る ↗説明
When working with small models sometimes my fingers just are too big. So I made a fully printable hand vise. Print everything in PLA with a layer height of 0.2mm or lower. Support is not needed. The thread is close to M12 and should work directly after printing. Lubricating the thread is recommended - I am using candle wax for that. If you want, you can re-cut the thread with an M12 tapper, but that should not be necessary. For the hinges I designed hinge rivets. To install the claws insert the claws and the hinge rivets, heat up a screwdriver and press it on the small end of the rivet. The rivet will melt in place. | Download free and paid 3D printable STL files
About this model
Printable Hand Vise by Blech Eimer is a 無料 3D model in the その他 category, shared by the MyMiniFactory community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on MyMiniFactory. Use the button above to open the original page and download it.
