manual helicopter

説明

This model is made up of 5 elements, all easily printable without any support or special technique. Interlocking these elements turns the propeller, which flies up to a height of around 5 or 6 meters. This game is perfect for outdoor fun with the kids. Have altitude contests, etc... Additional surfaces are added at the end of the propeller blades to prevent peeling off during printing. These surfaces must be removed after printing. Assembly tip: Clean parts thoroughly, removing all threads and printing imperfections. Ensure that the axis and rotor rotate freely in the hander. Use string with a diameter of less than one millimetre and a length of about 80cm. When using, pass the string through the hole in the propeller shaft, then insert the shaft into the rotor, passing the string through the slot in the shaft. Wrap the string around the rotor in the direction of the arrow. Then insert the rotor into the hander. Then pull the string with the puller. This model is made up of 5 elements, all easily printable without support and without any particular technique. The interlocking of these elements makes it possible to turn the propeller which will fly into the air up to approximately 5 to 6 meters in height. This game is perfect for having fun with children outside. Do altitude competitions, etc. Additional surfaces are added at the end of the propeller blades to prevent separation during printing. These surfaces will need to be removed after printing.