Customizable Snap Together Cable Label

説明

This is a customizable cable label that snaps together around a cable. The current dimensions are 30mm length with a 7mm inner diameter hole. I snapped this around a Midland GMRS Radio handset cable. The dimensions are fairly tight so I encourage the high quality. When snapping together do one side then gently push the tabs in with a small screwdriver and gently snap together. There are two different upper portions in case you want raised or sunk letters. I printed with tree supports with the flat side of the bottom to the bed and the tabs down letters up to maintain letter visiblity. Be careful removing supports. I'd make sure to clean up the holes and tabs with an XACTO before snapping together. If the tolerances are too tight scale one side up or down as needed slightly. You could likely take it apart but I'm unsure if the SNAPS would survive. Download the top pieces to Tinkercad or Fusion 360 to add your own text.