Spraybottle Holder

説明

Walls: 4 (for strength) Enable retraction and on layer change Z-hop: When retracted and set height to 0.6 mm (to avoid hitting the honeycomb pillars, as they will most likely curl up a bit). Combing Mode: All (also to avoid ramming into the pillars) Max Combing distance with no retract: 3 mm Make sure you have not enabled outer walls to be printed first, as the overhangs will likely fail if you have. Print with brim for better adhesion. Print with opening surface downwards, and you won't need support. If your printer is calibrated properly, this print will have no issues. The finished print can be turned upside down as well, but I recommend installing it as shown in photo, for maximum strength. Will fit most types of spraybottles. One 3mm screw will be enough to hold a regular, full bottle. Second hole is for positioning, though it's optional. Don't tighten too much, or you risk breaking the plastic. Print time is approximately 2 hours. Leave a comment if you need different dimensions. Please respect the non-commercial attribute. I use my designs to sell finished products and would be sad to see others taking my work and selling it. As such, I have implemented a 'watermark' that should not be overly visible. :) Send any requests or inquires to info@lumiax.dk