Birdhouse with geometric pattern
- 14 閲覧
このモデルは Cults3D で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。
Cults3D で見る ↗説明
Supports highly recommended. I printed mine without, but the bottom and the "ceiling" turned out a bit rough. Had to do alot of cleanup, and pretty much drowned it in acetone to get it nice looking in the end :-) Turned out much better than I had dared hope though :-) Now I just hope the birds will like it just as much as I do :-D Note: The two holes in the back of the top is for mounting a string. It's supposed to hang in a string, fastned 3 places - two in each side of the "cage" front top, and one in the rear holes. The five holes in the bottom is to allow rain to drain out. I think I pushed Tinkercad pretty close to it's limit with this one - it was quite slow to work with in the end, and it took about 10 attempts to download the stl without getting hit by a "bad gateway" error :-)
About this model
Birdhouse with geometric pattern is a 無料 3D model in the 動物・クリーチャー category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
