説明
Set action + fret height and compensation values in file. Goes under strings at nut, must fit firmly - strings must lay on this compensation to work. Print, middle one should be right one - depends on your action and printer - all three are same, differs only by one layer height. Before use this: - optionaly set octaves at saddle - luthier work for acoutic guitar, on my guitar 3th string compensation go at opposite direction then premade saddles compensation - set thruss rod and action (https://www.instructables.com/id/Acoustic-Guitar-Setup/, http://www.frets.com/FretsPages/Musician/GenSetup/NutAction/nutaction.html) Tune guitar and for each string: - fret string at 1st fret and use tunner (clip, build in or guitar tuna app) - if string is too sharp, than add .1-0.2 mm to compensation - if string is too deep, than substract -.1-.2 mm from compensation - correct compensation value in scad and go to next string Print again with corrected values and try again, you will probably need 3-4 loops of adjusting compensations. ps. there is some mistake in customizer, Action in should be 1.3
About this model
Guitar nut compensation is a 無料 3D model in the その他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
