Basher FPV Camera Mount

Описание

Works exclusively with the camera in the link below, has passed all of the durability tests on my basher. I have built in venting that is fed naturally as you drive forward to prevent overheating. parts: 2 m3 heat inserts and 2 m3 15mm screws or 2 m4 screws 2 breadboard wires with female ends 1 camera in the link below 3 m3 nuts and bolts for base mounting. Installation: 1: Install the camera in the mount and then connect the 2 breadboard wires. Mount the camera on your car where available. 2: Plug the wires into the correct polarity on any available port in the ESC, pay attention to + and - avoid the signal channel in the ESC. 3: the camera should power on when you start the rc car, connect any 5.8ghz display device and enjoy some FPC RC driving! You need to cut the plug off to feed the wires through, and its recommended to hit the top and bottom holes with hot glue to help prevent pulling on the wires or vibration on the soldering joints of the antenna…