CR-10S Pro - SKR Pro V1.1 SKR V1.3 and Ribbon Breakout Mount by Simon

Описание

This is a Mount for bigtreetech SKR PRO V1.1 / SKR V1.3 board and Ribbon Cable Breakout PCB Board, for the Creality CR-10S Pro. Mount was design from scratch,Fan and tunnel was modified/remix from https://www.thingiverse.com/thing:3838770 it is design for M3 screws. so all mount points are M3 threaded. hardware used1 X bigtreetech SKR PRO V1.1 board4 X 2209 Drivers1 X Ribbon Cable Breakout Board with I2C EEPROM (AT24C256)1 X 40X40X20mm fan, 40X40X10mm fan should also work.4 X M3 Stock Screws (used to hold the mount to the chassis)6 X M3 5mm Screws (hold the SKR and breakout PCB to the mount) (2 for the bottom mount of the SKR, and 4 for the Breakout PCB)1 X M3 8mm Screw (hold fan mount, into main mount)2 X M3 14mm Screws (for Ribbon Cable Adapter Plate)2 X M3 Washer (Optional for Ribbon Cable Adapter Plate)4 X M3 25mm Screws (hold 40X40X20mm fan into fan mount, i only used 2 screws)1 X M3 30mm Screw (Top Left mount hole. hold the tunnel, SKR board to the mount)1 X M3 35mm Screw (top right mount hole. hold the tunnel, SKR board, and mount. screw in the actual metal chassis) --------------------------------===========Update-------------------17/11/2019 added Ribbon Cable Adapter Plate V1to be used where the ribbon cable comes out of the chassis/case.Remove OEM retaining bracket,push through usb cables and micro sd card extension cables through.---Order of installationleave ribbon cable flat on chassis,put flat part of Ribbon Cable Adapter Plate on top of Ribbon Cable,insert…