Anycubic Mega Direct Extruder (TITAN)

Описание

ENGLISH (перевод на Русский ниже по тексту) ** Introduction **: This modification is a deep Mega Direct (https://www.thingiverse.com/thing:3710090) rework. Cooling based on Mega X-Carriage MK3, modified for compatibility with E3D V6/V5/VULCANO and it has the ability to move elements to access hotend details If you have any questions or suggestions, please write in the comments. If you want to thanks or support: PayPal (https://paypal.me/LilianzDonate?locale.x=ru_RU) Yandex money (https://money.yandex.ru/to/410015684782975) Benefits: Allows you to reduce the length of retracts and K-factor in Linear Advance, significantly reducing printing time Improved material flow control results in improved printing quality of corners and seams Possibility of printing with flexible filaments Enhanced and optimized design allows for increased acceleration (recommended values are listed below) No parts other than standard Anycubic I3 Mega S parts are required for Assembly Support E3D V6/V5/VULCANO Support motor up to 32mm long(standard anycubic Mega S motor) with little loss of print area on the X axis High-quality cooling with z-axis height adjustment Optimized for mounting the latest versions of Mega S High-quality mechanism-belt tensioner The relatively low weight of the assembly Recommendations for assembly and calibration: NECESSARY check the perpendicularity of the hotend axis to the table plane (the table must be in the adjustment position close to the bottom to reduce the…