Olight PL-X Kill flash

Olight PL-X Kill flash

Бесплатно STL Прочее
  • 16 просмотров

Эта модель размещена на Cults3D. Файлы, изображения и лицензия принадлежат автору.

Открыть на Cults3D ↗

Описание

Honeycomb kill flash for your Olight PL-X. The kill flash connects as a press fit cover that clips into place using the features of the PL-X. The kill flash will fit without modification. Based on previous designs, this should withstand several (5-7) direct close range shots from an Airsoft gun. I recommend printing in PLA-CF or PLA. However, due to the heat that the torch emits, I would avoid leaving the torch on for more than 1 minute at a time. After about 45 seconds, the torch builds up enough heat to deform the PLA. Possibly printing in a more heat resistant plastic such as ASA would be more robust against the heat generation.

About this model

Olight PL-X Kill flash is a бесплатно 3D model in the Прочее category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

Похожие модели