corkscrew holster

Описание

This corkscrew holster was designed for dining room and bar staff, but thanks to its practical attachment clip, it is useful for anyone in a variety of situations.I printed the models using PLA, PETG, and PETG/CF; I do not recommend using ABS, as it lacks flexibility and tends to snap at the attachment tab.I used "Tree" supports (Auto), specifically the "Thin Tree" type starting from the build plate;the print orientation is upright, with the closure side facing the build plate (be sure to clear any supports away from the clip's teeth). The tree support branches passing through the attachment clip should extend only toward the top to support the internal bridge connecting the clip to the holster base; therefore, they must not adhere to either of the clip's inner sides.Layer height: 0.2–0.16 mm;Perimeters: 3 or more;Infill density: 35% Gyroid;In these latest versions, a magnet has been added to hold the corkscrew in a fixed, static position until it is removed. The magnet measures 1 cm x 2 cm x 3 mm (actual caliper measurements: 9.7 mm x 19.10 mm x 2.57 mm). In any case, these dimensions should not cause confusion when purchasing the product shown in the Amazon listing. Cyanoacrylate glue is used for assembly.Questo fodero per cavatappi è stato pensato per gli addetti ai lavori di sala / bar, ma grazie al pratico clip di ancoraggio è praticamente utile a tutti, in svariate circostanze.Le stampe da me fatte sono state realizzate in PLA, PETG, PETG/CF, sconsiglio di usare l' ABS…