Cat Feeder using 4" PVC Pipe
- 22 просмотров
Эта модель размещена на Thingiverse. Файлы, изображения и лицензия принадлежат автору.
Открыть на Thingiverse ↗Описание
Yet another cat feeder but one that has served well. Rather than tie up the printer (and material) by printing the container tube, this one uses a length of standard 4" PVC pipe. The cover is designed for that, too. There's a little section in the OpenSCAD code to change the name on the lid to that of your cat.The feeder is "automatic" in the sense that the cat can learn to paw the dispense hole a bit to get the food to resume dribbling out if it gets hung up no and then.Since there's some volume bulk to the design, you can use low infill and still have strength. If concerned, you might boost the vertical wall number to 3. No supports necessary.
About this model
Cat Feeder using 4" PVC Pipe is a бесплатно 3D model in the Животные и существа category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.
