Strawberry support with lockable legs

Описание

Strawberry season is upon us and my experience is that the fruits don't like to be on the ground in dirt and mud because it is prone to rot. Why it did not evolve to be a bush instead is beyond me, but hey this is a good opportunity for some problem solving with 3D printing. I am using store bought strawberry supports and since I have a printer, I was also downloading and testing some designs, but I haven't found any that worked for me perfectly, so I set out to create one from scratch to incorporate what I have learned by using these. Features: Support size: 23 cm (~9 inch) diameter Leg size: 10 cm (4 inch) - you can push it to the ground to set your height preference The round support is cut in half to allow for easier insertion close to the plant. Each half has 3 legs, so it will not topple over Legs are printed laying down, instead of standing up so it will be much stronger this way Each leg is pointy, so it will allow for easier insertion to the soil (our soil contains a lot of clay) Each leg has a strong turnable locking mechanism to keep it in place, no glue required. This was one of the things that pointed me to design my own one, since none of the designs I found had it and legs were always a pain. If you glue them in, it will take up too much space for storage while it is sitting in the shed waiting for the next season. Word of caution/ additional tips and tricks: ASA recommended since these will be bombarded with UV rays from the sun, so if you want them to serve…