Sequential shifter for simracing

Sequential shifter for simracing

Бесплатно STL Прочее
  • 12 просмотров

Эта модель размещена на Cults3D. Файлы, изображения и лицензия принадлежат автору.

Открыть на Cults3D ↗

Описание

Budget friendly diy sequantial shifter for simracing. Materials you need: 4x M8 20mm screws 2x M8 nuts 1x 150mm threaded M8 rod 4x 14mm M3 socket head screws 1x Thin M8x1x2.5 nut 10x M5 7mm socket head screws 10x M5xL6xOD7 heat threaded inserts 4x 608 2RS bearings 2x Flat washers M8x20x1.5 1x 35x17x2mm spring 2x V-156-1C25 micro switches 1x Arduino Pro micro (NOT EVERY ARDUINO PRO MICRO IS THE SAME SIZE) you looking for 35x18.4x1.5mm without counting the usb-c M8 Shifter Knob some small wires Tape and grease lubricant The plate for clamps is just a bonus, it is bending because the clamps are only on one side but for my desk was only option.

About this model

Sequential shifter for simracing is a бесплатно 3D model in the Прочее category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

Похожие модели