Hawke Champion Armor 3D models

Описание

This model was designed for FDM printing with PLA filament. Hardware may be printed with resin, but I don`t recommend it for the armor - most UV resin lacks the required flexibility and cannot be thermoformed. Besides, resin printing might appear to be too fragile for the large props. Use tree supports at standard automatic settings, and provide a good adhesion to the plate (brim and glue). A 15-20% infill is enough for this project, to enlighten the prints you can go with 5-10%. The set is designed for 180 cm tall male. If your height is significantly outside that range, rescaling is recommended. According to the design, the armor appears to be 85% of the size on female body type in comparison to a male of the same height. Rescale the models for female body type.