Laser Raygun

Описание

3D printed raygun that uses a basic laser pointer and a trigger mechanism to allow it to "shoot" the laser with a press of the trigger. Print the barrel in bronze, trigger and handle in black, and backend cover and trigger peg in either of those colors (i did black). You must use this SPECIFIC laser pointer or else (it most likely) will not fit correctly--https://www.amazon.com/dp/B0F8BLY5BJ?ref=ppxyo2ovdtbfedasintitle&th=1 You must take off anything unscrewable on the laser pointer, the "filter" silver part on top, the top piece (the top part that the silver part screwed on to), and the bottom screw covering the USB--the USB is uncovered so it can be used to assure the laser pointer doesnt rotate by accident. Everything just slides together and tightly holds other than the handle, which just uses superglue. To assemble: Insert Trigger and trigger peg into place (the trigger may be a little tricky, and may require some force to slip through the bottom slit). Insert the laser pointer through the back open end, it should slide all the way down and the little small lense on the end of the laser pointer should line up flush on the front end of the barrel (inside the square part). Make sure when you insert the laser pointer, that you put the button facing upwards, and before you fully push the laser pointer in, add the backend cover snug onto the usb. After that, push everything as far down as possible, the lense of the laser pointer should go flush on the front of the barrel…