Spoolholder by Marc

Описание

This Spoolholder was created as part of the 3d Printing Nerd design challenge for a spoolholder that can easily be mounted to his filamentshelfes. However when you have a 3/4" (18-19mm) deep board, this spoolholder might be for you. I submited another design that prints faster but the spool is oriented in a 90° angle towards the spools left on the shelf, but all the other features of this design still apply. Features: Prints in one Piece, without supports Fits 30cm (11,8 inch) spools Loadtested up to 6 kg (13,23 lbs) (using the provided printig details) can be printed on a 20cm x 20cm (7,9" x 7,9") printbed no additional hardware needed NOTE: Check your print for underextrusion since this can significantly decrease the stability, especially when occurring on the small back part. | Download free and paid 3D printable STL files