Electronic Surface/Height Gauge

Описание

An add-on to your electronic caliper (fits most standard calipers). 2 version of calipers width - up to 16mm width - up to 17mm width The gauge can be used to Router and Table Saw. This is of course NOT a high precision solution, but it is quite flat and does its job within a 0.05mm error range. Assembly and Use The hole is 3.5 mm diameter, so you can screw in a M4 bolt/screw without the need to cut a thread. - Insert the caliper and fix it with a screw. - If necessary, install a heel on the caliper probe. - Place the gauge on a smooth, flat surface. - Lower the caliper probe until it touches the base surface. - Zero the caliper. Now when you lift the probe, the height will be displayed (as a negative value) See also: Mechanical Surface/Height Gauge (https://www.thingiverse.com/thing:6826719) Surface Gauge (https://www.thingiverse.com/thing:6823421)