MIcrophone Kit by Simone

Описание

I don't think there is a need to explain what it is.For a visual reference on the dimensions the measure of the outer circle is 64mm.I ordered on Aliexpress (I will put the links at the end of the description) some condenser microphone capsules (pack of 10) and I have put into activity 9 to keep the value of the capacity unchanged, but the printable parts are also valid for a single capsule of any dimension that can enter the body. Customizing the capsule holder (number 0 in the files) is very simple.In the images you should easily understand the assembly method which is however very intuitive. Those in yellow are rubber bands (very soft) that must be adapted in length and locked (I used knots of very thin wire for electronics) so that they hold the capsule block suspended, inside the body and then the body all the way inside the cage.All the parts to be assembled must be glued and inside the body, a 4/5mm axis must be inserted into the 4 holes (of files 6&7) obtained from a clip for office sheets (attach).The holes under the base are used to house magnets (if you have metal parts to attach it to or you can change shape or close it).the preamplifier box is just as simple and the ideal is to power it with battery (minimum 3v maximum 9v), I use two li-po in series (about 7.4v are fine), but a 9V battery is also ideal and lasts a lot , if disconnected when not needed.. The small screwdriver is used to adjust the gain, in the absence of something better at hand, but once you…