Kazoo holder

Kazoo holder

Ücretsiz STL Gadget ve Aksesuar
  • 17 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

This is a kazoo holder to be put into a usual harmonica neck holder. I've printed it with my cheap wooden Geeetech Prusa printer. Additional needed parts: - harmonica neck holder to combine top part and bottom part: - 2 screws M3x20 DIN 912/ISO 4762 - 2 Nuts M3 DIN 934 to fix side parts: - 2 Screws M3x16 DIN 912/ISO 4762 or similar - 2 Washers 3,2 DIN 9021 or similar and a little part of rubber mesh or rupper plate to be clued on the inner bottom face of the bottom part. With this rubber it is not necessary to tighten the screws to strong so that the kazoo may be damaged.

Bu model hakkında

Kazoo holder, Cults3D topluluğunda paylaşılan ücretsiz bir Gadget ve Aksesuar 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller