FlashForge Pro Fan Holder

Açıklama

This is a remix of two ideas: https://www.thingiverse.com/thing:327387 https://www.myminifactory.com/object/flashforge-creator-pro-fan-duct-2058 It is a 'press-fit' holder that mounts onto the FlashForge Carriage under the right Extrude Fan. It takes a 10mm deep 40mm Duct Fan. We prefer an independently wired outside power supply for the Fan with a switch to turn the Fan on/off FYI. You can remix this to fit the left side too. BUT a Dual Fan assembly may be unfeasible ... but not to worry, most people use Only the Left or Right side nozzle for PLA printing. Printed with these settings using Simplify3D: PLA 0.15 layer 10 top layers, 10 bottom layers, 2 outline shells 12% infill 35c bed temp 200c nozzle temp 60mm speed