Knobs with Caps

Knobs with Caps

Ücretsiz STL Diğer
  • 11 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

Yet another bunch of knobs for metric 6 (M6) and metric 8 (M8) bolts and nuts. Use caps with holes for nuts and others for bolts. The housing for the hex head of bolt and nut is a bit tight by purpose. Do not hammer them into these printed parts. Instead, use the method of fastening them in opposite direction. This will pull them into its places. I have shown this method in an animated gif below. Caps are also coming little tight. Use a vice to push them into top openings. I used PETG on Prusa I3 Mk3 and utilised Ultimaker Cura 3.3.1 with 0 (zero) Horizontal Expansion setting. If you encounter loose fits, then you might consider to try Ultimaker Cura 3.3.1. Happy printings.

Bu model hakkında

Knobs with Caps, Cults3D topluluğunda paylaşılan ücretsiz bir Diğer 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller