NES Mini PC Case

Açıklama

This is a 60% scale NES Nintendo case I designed from the ground up. I designed this case around the AK1J3455 mini PC. These small PC's can be found for around $30. Mine had a 128gb rom chip, so I didn't need a hard drive, although it did have a SATA cable to add a 2.5" hard drive. It also has WIFI and Bluetooth on board and integrated graphics. I don't know what other versions will fit, so for compatibility I can only say the AK1J3455 will work. I'm using this with an OS called Batocera for emulating my retro games. I haven't tried my PS2 games yet but I'm sure it can handle them. I have played my NES, SNES, Sega, N64, PS1, ScummVM. Items needed: -AK1J3455 mini pc -(1) 5mm red LED -(1) 6x6x5mm push button -some small wire (for power button and LED) -some m2 fasteners STEPS: -print order: buttons and button holder, case bottom, case top, vent, then front and rear fascia. -After you print the button holder you can start building this while the case bottom is printing. You will install the push button in the button holder so that the legs of the button fit through the slots and glue it in place. Then glue your led into the hole next to the button. Then you can solder about 6" of small gauge wire to the legs of the button closest to the LED. Also solder the same length of wires to the LED. Then connect the wiring to the PC according to my pictures. Positive of LED goes to Yellow wire and the Negative goes to the Black wire. Red wire not used. The wires from the switch to the…