Stone Golem Gorget

Açıklama

A heavy, stone-inspired gorge/neck armor designed for fantasy warriors, golems, guardians, and ancient constructs. The cracked stone surface and layered geometry give it a carved-from-rock look while remaining wearable and printable for cosplay or display. Perfect for fantasy cosplay, LARP armor builds, statues, or action figure scaling. 📏 Measuring Instructions (Cosplay Wearables) For best fit, use a digital caliper. Measure directly on your body or a fitted mannequin: Neck inner width – measure straight across the front of the neck base Neck depth – from collarbone center to back of neck base Shoulder spread – distance between collarbone edges Desired drop length – how far the gorget should sit on the chest Scale the model uniformly in your slicer based on these measurements. For comfort, allow 6–10 mm clearance around the neck opening. 💡 A hairdryer or heat gun (low setting) can be used after printing to fine-tune the fit. 🖨️ Printing Instructions Recommended layer height: 0.2–0.28 mm Wall count: 3–4 Infill: 10–15% (gyroid or cubic) Supports: depends on the orientation and how you cut it. Recommended Filaments PLA PLA-HT (best balance of rigidity and heat resistance) FPLA Elastan / flexible filaments for softer, wearable comfort PETG 🎨 Finishing Tips Prime with filler primer to soften layer lines Dry-brush light stone tones over a dark base Add black or brown washes to emphasize cracks Seal with matte varnish for realistic stone texture