Small table or stool leg connector. Simple and sturdy.

Açıklama

Connector designed to build nice tables or stools with ease. Remove the complexity of wood joinery with this 3D printed model. The connector is designed to angle the legs by 8 degrees, witch is good for coffee or sitting tables or stools, but may be too much an angle for tall tables. You will need 5 screws per connector: 4 to attach to the tabletop and another (can be smaller) to secure the leg. The connectors have a notch in the centerline to help positioning. In the example table from the images I angled them to point to the tabletop corners. Instructions: Create a nice table board. Cut simple legs, no need for fancy joinery. Mark the position and screw the connectors to the table surface. Slide the legs and add a small screw to secure in place. Cutting the legs: The legs need to have a section of 59mm x 38mm to fit the conector. The connector height is about 60mm, after that distance you may taper the leg to your liking. The length of the legs is up to you. Keep in mind they will be angled by 8 degrees from the vertical. I recommend cutting the edges to 8 degrees for the legs sit flush with the tabletop.