Runout Sensor holder

Runout Sensor holder

Ücretsiz STL Gadget ve Aksesuar
  • 14 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

I made this for the Two Trees Sapphire/Sapphiros Pro/Plus/SP-3/SP-5 but it will mount on any 2020 Aluminum Profile Extrusion. You will need: - 2xM3 screw - 2xM3 20 Series Sliding Drop-in T-nut: https://www.aliexpress.com/item/4000149500597.html?spm=a2g0s.9042311.0.0.27424c4dMPf4XQ The connector needed is a "JST-XH" 3-pin In configuration.h you'll need to make sure you have this: #define FILAMENTRUNOUTSENSOR #if ENABLED(FILAMENTRUNOUTSENSOR) #define NUMRUNOUTSENSORS 1 // Number of sensors, up to one per extruder. Define a FILRUNOUT#PIN for each. #define FILRUNOUTSTATE LOW // Set to true to invert the logic of the sensor. #define FILRUNOUTPULLUP

Bu model hakkında

Runout Sensor holder, Cults3D topluluğunda paylaşılan ücretsiz bir Gadget ve Aksesuar 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller