Toad face on window

Açıklama

A cute 3D printable Toad figure from Super Mario, prepared as a ready-to-print model file. The model is approximately 14 cm tall when assembled. The file is fully prepared for printing, and all required slicer settings are already included in the model file. Print settings included: Layer height: 0.2 mm Infill density: 10% Infill pattern: Gyroid Supports: Enabled Support type: Tree Hybrid Support angle: 25° Ignore small overhangs: Enabled Top support Z distance: 0.16 mm Top interface layers: 3 Top interface line spacing: 0 Maximum bridge length: 10 mm Independent support layer height: Disabled Branch angle: 60° Branch diameter angle: 3° Flushing volume: 1.3 For printing the body part, a pause is set at layer 170 so the filament can be manually changed from white to beige.