easy lock small round container in 2 version (basic,for keychain ring) V2

Açıklama

triple thread easy lock small round container with and without hole for hanging on approx:20mm - 25mm keychain (with 5 variations of tolerances for threads)so no worries for all machines Lid v2 with 12.5 mm diameter hole for attachment to the carabiner -easiest thread to print - not very usual 6x external thread (3 external threds on outer and 3 external threads on inner body)with a large pitch angle -with 5 different options of tolerances for threads.: 0, -0.15mm, -0.25mm, -0.5mm, -0.7mm( toleration between threads) -the maximum need to turn the lid for locking corresponds to 180 degrees from any point around the perimeter of the lid ready to use from printer bed no suport needed recommended print -0,15 if your printer is well set up you should be fine -0,15 means toleration between threads of outer and inner body - they are not usual and all threads are external due to the locking design of this box, I recommend tightening it strongly but with sensitivity to ensure sufficient contact between the walls of the threads when closing - you will immediately find out what I mean with the first piece -0,5 tolerance is ridiculously high tested with 0,8 nozzle the thread was loose but still functional -if you need this or a larger tolerance range, because of any geometrical errors your printer is definitely not in good condition and probably diverges between the X and Y axes means they are not in right angle (90degrees)- -!!!-extra fit version is challenge print-!!! if you consider…