Printer Test 1

Açıklama

Printer Test If you will print this CUBE of 10x10x10 you can measure: -If the printer is correctly calibrated USE CALIPER to verify each parameter 10mm on every side 5 circle side (radius): -0,25mm -0,5mm -0,75mm -1,5mm Big hole: 2.5mm Side circle: 0,5 mm Side square: -,5mm NBR letters on bottom to test the overhangs Overhangs is also tested on the big hole 3 types of edges: rounded, chamfered of righted With this print test you can also see the path on the bed. Use this cube for every type of material. In my point of view you can observe all types of faults that can appear after you will make a temperature tower. I use this one with no support. ( You will have a little overhangs on the big hole ) Message me if you have any question. Let me know if i can help you with anything. You can also find me on tiktok, instagram and faceebok: Nibora Shop 3D