Fat Body Grub Mold

Açıklama

This is a 6 cavity mold for a fat body fishing grub. This was designed for a How to design video on YouTube to show how you can design your own molds. The video can be seen here https://youtu.be/B8BbljcbZVQ Each mold half requires about 6.5" x 5.75" of bed area to print. While this mold works and does turn out some cool grubs it did give me a lot of issues with denting so keep that in mind. This is a 3D printed plastic mold so you have to be careful with your temps and injection pressure. I printed this mold in PLA+ and try to inject my Plastisol at or around 300°. (I use Dead On Plastix's brand of Plastisol) You also need to use very little pressure on the injector when shooting these types of mold. If you use a lot of pressure when injecting a 3D printed Mold... you can/will blow through the mold. Start light and work up with the pressure if you do not get a full injection or you have bubbles. It's better to have a misformed bait or two than ruin the mold. The Video link below shows How to Inject a 3D Printed Mold, I'd recommend watching before purchasing my molds. https://www.youtube.com/watch?v=_FeUszxAK8s NOTICE - My files and designs are all Copyrighted © and are exclusively for private and personal use. Even if you purchased these files that Copyright means you are NOT allowed to sell the model or any derivative of the model for economic or financial gain. For example, you cannot sell the digital model, a derivative or adaptation of that model, nor can you sell prints…