Parallel Gripper for EEZYbotARM MK2

Açıklama

This is a remix of my Rov Manipulator (Parallel Gripper) (https://www.thingiverse.com/thing:4362236) modified to fit the EEZYbotARM MK2 (https://www.thingiverse.com/thing:1454048) robotic arm and be controlled by a servo instead of a rotating shaft. Use a SG90 Servo Hardware required (See pictures for screw layout.) All screw holes are pre-tapped (4) 2-56 x 1/2" screws (2) 4-40" x 3/8" Button Head Screws (2) 4-40 x 1" Flat Head Screws Servo Mounting screws. Some of the parts will need to be oriented to be printed properly. See pictures for the layout I used. The fingers, forward hinges, and Pad need to be printed x 2. The finger pads were printed in a flexible filament for better grip but can be cut from rubber. See https://www.theneverendingprojectslist.com/raspberrypiprojects/raspberrypiroboticarm/ for more info.