Coil drawer

Açıklama

I couldn't find a drawer for the wholesale3D reels, so here they are. Apparently this is a standard reel format and the ribs are a little lower. The design was made with the constraint of using as little filament as possible, so it can be a little flexible, for the little it's used for, I find it more acceptable than wearing out a spool to recycle its support. I've added a 2-part spacer system to compensate for the height of the screw heads and center the coils in relation to each other. These coils need to be counter-drilled for a better hold, precision is not the most important thing and a template is also supplied. The drawers are "theoretically" M4 tapped, so screws can be forced in, but it's still better to tap the drawer first. There are now (slowly) printing counters to replace these screws. F3d supplied if needed to change dimensions or other . drawer height 50 -> D. int. 94 - ext. 198 - ht. 50 (53 for pivot part) coil dimension height 50 -> D. int . 94 - ext. 200 - ht. 63 drawer side height 33 -> D. int. 94 - ext. 198 - ht. 33 coil side height 33 -> D. int . 94 - ext. 200 - ht. 43 edit 04/27/20: added a tracing template ( not yet tested ) added drawer dividers and pins to replace screws added drawer ht. 33