Olight PL-PRO Killflash

Olight PL-PRO Killflash

Ücretsiz STL Diğer
  • 12 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

3DP kill flash designed to protect your PL-PRO against any initial stray bbs during an Airsoft game. The honeycomb structure allows plenty of light through whilst protecting the lens. In testing, this has survived 5 direct shots at close range and still had the potentially to survive a couple more shots. Securely attached over the lens, with some flex to allow you remove it if necessary. I recommend printing out of PLA, however, note, due to the heat generated, the PLA may warp and soften after prolonged period of the torch being turned on. If you're worried about this, I recommend using ASA instead.

Bu model hakkında

Olight PL-PRO Killflash, Cults3D topluluğunda paylaşılan ücretsiz bir Diğer 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller