K2 Plus – CFS Riser, and Storage

Açıklama

Some people have reported that when they printed, the tolerances were too tight for their printer to handle. The original, now called “Tight”, version has tolerances of 0.14 mm. There is now also a “looser” version that has tolerances of 0.21 mm. This applies only to the seam down the middle front-to-back, as it was reported the other seams were fine. There is a test print for each of these, and I highly recommend printing it to make sure your printer and desired material will work.In V1, there was a minor design flaw in Parts 3 and 4. There is a part on the bottom of the CFS that juts down that I did not account for. If you already printed parts 3 and 4, you can print 2 of the feet risers and drop them into the back two slots. You will never know the difference.This is a big print, and has been a big effort for me to make, so I hope that you enjoy it.