JCB joystick arm without button

Açıklama

The joystick arm of my friend's JCB has broken. A new one is a bit expensive and he did not want a full new joystick arm. So I made them a model, I printed and he could use this solution. This joystick arm is can be fitted to JCB 8016, or 8014 or 8016 or 8018. So when you want to use our solution, you will need an M12 threaded rod extension, an M12 nut and an M12 threaded rod. After when you printed the model, put the rod extension to the joystick, and screw the threaded rod to the part. Mark where you want to bend the threaded rod so that it is at the right angle. Screw back, bend it. Put a nut on it for locking and screw it back to the part. Lock the locking nut on the threaded rod extension, and you can use. If I can, I will make better photos, where the joystick is in the JCB.