Nerf Crossbow

Açıklama

https://www.youtube.com/watch?v=YuyjK7GAs_gThis was designed from, and shares a lot of pieces in common with the modular crossbow/slingbow project.Careful attention must be paid to slicing these .stl files in prusaslicer to get the best results. Several .ini files have been included. The recurve arms are the most difficult part,the aim is to get these on the edge of over-extruding but not so much that the blob up or otherwise fail. The larger trigger pieces should be printed with as many perimeters as possible, and 100% (or close to 100%) infill to maximize strength. All the parts should be printable without support in the proper orientation. Some that have tended to curl up or lift of the print bed have some partial rafts added that should be removed after printing.Print Settings Files (0.4mm nozzle only)0.25mm_STANDARD_PETG.ini - For most parts. Layer height can be adjusted if more detail is wanted.0.25mm_SOLID_WIDE_PETG.ini - For the recurve arms only. Intentionally overextruded, I had no problem printing with these, but watch the printer closely while printing to ensure it does not blob up or otherwise fail.PETG_0.92e_240C_1.75mm_FAN.ini - Generic PETG for most parts. Temperature, etc. parameters can be tuned to specific type of PETG. PETG_1.00e_240C_1.75mm.ini, PETG_1.05e_240C_1.75mm.ini, PETG_1.10e_240C_1.75mm.ini - For the recurve arms only. I started with 1.05e, and increased to 1.10e if under-extruding, or decreased to 1.00e if over-extruding. Full assembly…