Soldering Base Only

Açıklama

Full Kit Purchase Link - $35 USD: https://www.scwd.us/scwd-products/scwd-soldering-station My Soldering Base UPDATE: 09/18/2024 Added V2 with lips to the tip, heat shrink tube, and solder flux inserts. Solder Flux insert ID is 32mm. (For a smaller flux liquid container) New design is for added support and to prevent anything from falling out. My Soldering Base UPDATE: 09/14/2024 Added (6) 13mm Anti-Skid feet inserts. Added (4) 7mm HAKKO Tip Inserts Redesigned the holder adding more girth to the knobs. (Not included) Added wire helper. (Not included) Enjoy! ABOUT: Made a custom soldering base with a detachable piece of 23guage sheet metal (165mm x 114mm) held on by 10mm x 3mm magnets. I put some electrical tape around the perimeter for the sheet metal to help with grip and mainly to not cut anyone that uses it. I've tested this and it does not melt the base plate. Time will tell. FEATURES: The large round 44mm hole fits 1 of 3 things. A tiner, flux paste, or electrical tape. The (4) 7mm inserts are for HAKKO Soldering tips. The square hole will hold your tips or heat shrink tubes. Fits a piece of 23guage sheet metal @ 165mm x 114mm. (6) 13mm rubber anti-skid feet inserts HARDWARE NEEDED: (1) 3mm x 12 bolt, washer, and nut. The nut is held in place on the bottom. (4) neodymium/rare earth magnets @ 10mm x 3mm. (Optional) Electrical black tape around the perimeter of the sheet metal for grip and protection. PRINTING SUGGESTIONS: I would use PETG, ASA, or ABS for heat resistance…