LCD + Hyperpixel 4" touchscreen cover (BEAR VERSION)

Açıklama

LCD + Hyperpixel 4 inch touchscreen cover remix for the BEAR UPGRADE. Hello, i remixed this model: https://www.printables.com/de/model/47153-lcd-hyperpixel-4-touchscreen-cover to fit for the BEAR upgrade. You need a higher surface for the bracket because I have adapted the angle of the cover weird to fit better in a housing. In addition, it looks like the original cover from the angle. This could be a concrete slab (40cmx40cm) or higher feet such as the squashball feet. These are also very recommended. Have a look here: https://www.printables.com/de/model/241857-squash-ball-feet-foot-for-bear-upgrade or here: https://www.thingiverse.com/thing:3385254 I have two versions: 1: One only for the Hyperpixel 4 inch touchscreen. (Then you need a IDC cable 40pol.) 2: For the touchscreen and a RPi. If you only choose the touchscreen, then you have to remove the two upper or lower noses with a cutter after printing to the image. The screen can then be fixed again with hot glue at these points. In order to be able to establish the cover on the frame of the bear, you have to borrow 2 holes with a diameter of 3.5mm with a distance from 20mm in the middle of the VSLOT. The other 2 holes must be offset exactly 120mm. You need 4x M3 screws (about 20mm long) and 4 M3 square nuts. If you need something to modify, i have added the Fusion 360 and STEP file. For the print settings, have a look at the source: https://www.printables.com/de/model/47153-lcd-hyperpixel-4-touchscreen-cover