Swivel

Açıklama

Printed @ 195 degrees pla, @ bed 0, 10%den,2,3,3. Rafts are included where necessary. Just pick the male/female end types you want give it a shot. I was not able to use abs on these builds, so I don't know how they will print in abs. Particular attention is necessary when printing and cleaning the male end. Remove rafts and cleanup under the arrows with a triangular file. I also use sandpaper to smooth things up. Can separate components by breaking one of the male end prongs. It takes some effort to push male/female parts together. It should take a lot of effort to pull apart. If the prongs print to ridged, they may break when pushing together. Like walls to thick, etc., so adjust the thicknesses to get the correct balance of flexibility. I started @ 100% speed for until I get to the prongs. Then finish at 20% using a fan on build if necessary. If build starts acting like jello, its to hot to form a good male profile. It is better to print at least 2 at a time to allow cooling.