INTUBATION BOX

INTUBATION BOX

Ücretsiz STL Düzenleyici ve Saklama
  • 17 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

This is a protective shield intubation box originally designed by Dr.Lai Hsien-Yuan in Taiwan. Boston Medical Center translated the content and demonstrated the procedure using this box. This original design was converted into inches for American makers. The revised design has three major new features. 1) Adding hooks: these four hooks allow the hospitalas to optionally cover the backside of the box while allowing operational access 2) pipe holes: two pipe-holes gives hospital options to either create a negative pressure environment or allow regular tubes and pipes in intubation operation. 3) Adding a new operational access on the side for two people's operation. This box design is of course not your typical, clinically proven PPE. Therefore please see this as another layer protection on top of the standard ones rather than your single source of protection. You can see the video link to see further information: https://www.nejm.org/doi/full/10.1056/NEJMc2007589

Bu model hakkında

INTUBATION BOX, Cults3D topluluğunda paylaşılan ücretsiz bir Düzenleyici ve Saklama 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller