4 Deck Blitz Ball

Açıklama

Bigger isn't always better, but in this case it might be! This thing is MASSIVE but it's awesome! also much easier to print than the 4 Deck Buster sword. TO PRINT THIS YOU WILL NEED A 256X256mm PRINT BED. THIS BARELY FIT ON MY P1S. I have provided a 3mf file. You will need to use this 3mf to print this correctly. It took me a minute to position the model correctly to so it was able to slice. The 3mf has that work done for you. Support will be required for the Lid. Also I made the holes for the magnets 8.1mm in diameter. This is a change from all of previous models. If you printer is well tuned you should just be able to push the magnet in place and it will hold. No need for glue. Magnet strength- I use these magnets from Bambu. I have tried ones off amazon and its hard to figure out what the strength is going to be these bambu magnets work well for me. https://us.store.bambulab.com/products/round-magnet?id=42424856477832 Consider becoming a member over on thangs. For $10 you can get all of my models. There is also the ability to become a commercial member. https://thangs.com/designer/thatcaddad