Plankton!

Açıklama

Plankton will get the secret recipe to the Krabby Patty someday!Sheldon J. Plankton was originally created to be a one-off character, married to his computer, Karen. He was voiced by one of the show's writers, Mr. Lawrence, who had more ideas for the character than originally envisioned. The show's creator, Steven Hillenberg describes him as "more of a caricature of a villain."This model shows plankton using a device to control Spongebob's brain.It's a large model, about 12" from base to antenna tip. I like the irony.In my example photo, he's actually greener than he shows there, but not as green as I like. Oh well, it's what I had on hand.Printing instructions:Supports: yes. I recommend tree support, maximum angle 45 degrees, from the build plate only.Adhesion: use brims, especially for the joystick shafts and knobs.Orient the body vertically for minimum scarring from the supports. Be careful; the legs are thin and could break if handled roughlyOrient the knobs vertically, resting on the collars.Print the joystick shafts horizontally, using brims. This will give more strength to the shafts and create a flat part where it touches the plate. This will help when you assemble the model.If you print the box separately, you shouldn’t need brims or supports.Post-processing instructionsA burr-removing knife is helpful. The shafts will clean up much nicer using this tool.Be gentle with the legs and antennae on the body.Assembly InstructionsGlue the…