Pegboard Blank

Açıklama

This is a "blank" pegboard piece. It is already measured out, and tested to work on most American pegboards with 1/4" holes. It is meant for you to use to make your own boxes, hooks, quick-grab bins, and other organizers. This will NOT work with Skadis boards. This also may not work well with some european peg boards, as their measurements are slightly different.You can either print this piece by itself and glue it to an existing object, or use any editing program to build your own and attach this piece to it. If you print it by itself, lay it down on the large flat side and you won't need any supports. If you attach it to something else, the pegs may need light support, depending on orientation. I recommend using tree supports and increasing the Support Object First Layer Gap or Top Z Distance to .5mm to make supports easier to remove.The pegs are set to cover seven consecutive holes, but most items won't need this many. I made an 8" by 10" bin and only used one on each end, and one in the center. You can delete the extra pegs with negative spaces in your editor, or leave them all there. Both options will work, one just uses less filament. Be sure to leave a bottom straight peg for all of the top pegs you keep, as this helps keep the item from sagging over time.This should work with any filament.