RC DS6 40mm EDF "Mini Delta"

Açıklama

My first RC Delta fighter created. It is based on the Rafale but I made it a single engine fighter, had 45 degrees wing sweep, and canards to help with creating vortices at high AoA. CG is marked a bit far forward of actual CG due to canards contributing forwards lift but it should fly fine as long as you are on the mark.Electronics List:40mm EDF30-40A ESC3S 11.1V 2200mAh2X SG90 or MG90 ServosFlysky IAB6 RecieverFlysky I6X TransmitterCA Glue for gluing the fuselage and wing pieces together. For this one, I printed this jet with PLA Basic but it didn't have enough thrust to weight to hand launch properly so I highly recommend any kind of LW-PLA if you wanna hand launch it. PLA is fine for durability, but you'll need to get a rolling dolly for it because the wing loading is higher and deltas usually need more speed to stay airborne than straight or mildly swept wings. Also, consider a HobbyEagle A3 gyro too if you are a beginner flying it cuz of this.TIP: Install servos (CA glue to the pocket) and elevons first and then add the wings to lock the elevons in place. CONTROL SETTINGS:Elevon MixingRates: 50-60%Expo: 45-50%